CartMy Cart | My Account | Checkout | Help

Shop by Manufacturer

RatePoint Site Seal

Pricom Design DCC Pocket Tester - Complete
Pricom Design DCC Pocket Tester - Complete
Quantity in Basket: None
Code: PRI-TESTER
MSRP: 179.00
TRAINTEK $149.95

Qty.

The DCC Pocket Tester is the only low-cost, portable, reliable, and accurate way to test and verify the DCC Protocol. The unit is completely powered from the DCC Signal, so no batteries to change, no power cord to remember, and NO PC required which makes it the ultimate tester for your toolbox.

Verification Tests

  • Signal timing

  • Voltage levels

  • Packet protocol adherence

  • Preamble bits

  • Checksum errors

  • Packet timing

  • Packet update rate

  • Gaps between packets

Monitor

  • Address utilization

  • Broadcast counts

  • Actual mobile and accessory data packets can be monitored, captured, decoded, and viewed.

Ever tried to calculate the error-rate on a DCC layout using a DSO? If you happen to have a VERY-LONG record length DSO, and a lot of time on your hands, you could probably figure out a few packets at a time. With the DCC Pocket Tester, you just connect the clips to the rails, and it will monitor 100% of the data on the rails giving you a 100% accurate bit-error-rate without any sampling and calculating time! An oscilloscope or a sound card can not monitor 100% of the data, they require sampling and calculating time, potentially missing bad bits. With the DCC Pocket Tester, not a single bad bit or packet will be missed. Leave the DCC Pocket Tester connected to your layout for hours or days, it will count up to 4 BILLION bits, 4 BILLION packets, and 4 BILLION bad bits without missing a single one! What you get is a combination Communications Analyzer and Protocol Tester specialized for DCC Model Railroading!

The firmware used inside the DCC Pocket Tester is completely upgradeable. All you need is a PC and the special Serial Cable. Using the included software, connect the DCC Pocket Tester to a Serial COM port on your PC, and upload a new Firmware Image to the Tester.

New in firmware version 1.4 is the ability to send ALL DCC packets to the RS-232 Serial Port. This allows an external program such as HyperTerminal (free with Windows) to display decoded DCC packets right before your eyes in real-time!


TRAINTEK, LLC 1-888-339-TRAIN (8724)

Copyright 2008-2010 Traintek, LLC All Rights Reserved.