The PM42 breakout board brings out all the connections available on the Digitrax PM42 to easy access screw terminals.
The PM42 breakout board is setup to accept up to 2 inputs and 4 distinct outputs.
Each output uses a set of jumpers that allows you to set that particular section to reversing, assuming the correct OpSwitches have been set inside the PM42's memory.
NOTE: As of December 1st 2015, PM42 Breakout boards will be shipped with only 1 set of jumpers for the outputs. Additional jumpers are available here.
Digitrax PM42 not included.
4 Reviews Hide Reviews Show Reviews
Company cannot be reached or at least does not return calls. And their instructions are extremely vague and minimal another page or two and maby a diagram would of helped for sure
This is a great product. It simplifies the wiring connections that are required and provides a mounting base for the board as well.
It works extremely well in conjunction with other break out boards.
A must have if you dislike soldering larger gauge wires in tight spaces and having to un-solder when you change components.
Easy, straight forward instructions. Minimal screw connections make for a neat and very easy installation.
After soldering the first PM42, this is a great idea. It only took 5 minutes to connect all the wiring. Unfortunately, the manufacturer stopped including the necessary jumpers to make all four sections reversing units. Be sure you order the extra jumpers if you need them.