The LT1 is included with all Digitrax Starter Sets. It consists of a harness with 6 conductor Telco type wire and a male plug, a tester with a female 6 conductor jack and a protection resistor.
If you make your own LocoNet cables, this is a handy device for testing them. It can also be used for testing existing LocoNet cables if there is a suspected problem.
Testing LocoNet Cables:
- Disconnect the harness from the LT-1.
- Plug one end of the cable being tested into the LT-1.
- Connect the other end of the cable to any Digitrax Booster Port A or B.
- All four LEDs on the LT-1 will light if the cable is good. If any of the LEDs fail to light, re-crimp the plug on the end of the cable and re-test.